i-Drive Walk-in System for Passenger Seat Control (BMW G30)

i-Drive Walk-in System for Passenger Seat Control (BMW G30)

BMW 5 Series(G30) In The INDIWORK Garage.

*
i-Drive Walk-in System
(CAN Control)
*

Use Device : IW200 (Walk-in Module)

————————————

ㆍCAN-BUS control walk-in system
ㆍSupport the BMW, AUDI, Volkswagen, Grandeur 5G
ㆍControl the exact position without error. (CAN-BUS control)
ㆍControl to the passenger seat by original button.(BMW : i-Drivier / AUDI : MMI / VW : Genuine steering wheel buttons)
ㆍNo damage car seat
ㆍCan be installed to various types of vehicles because change dip switches.

This is a system using CAN data of the vehicle.
Therefore, there is no damage to the vehicle, it is easy to restore the original.

The iDrive walk-in is a system that controls the assistant seat and the backrest by using the genuine jog dial of the vehicle.

When installing a work-in system, connect the CAN wiring and power of the IW200 module, and make sure that the module receives the car’s CAN signal and is operating normally. Then connect the IN / OUT of the motor wiring.

And connect IN / OUT of seat side control wiring.

Connect the IN / OUT of the control wiring on the backrest side.

Remove the armrest to connect the CAN wiring under the i-drive.

Bridge the CAN wiring on the i-Drive side.

IN / OUT connection of motor wiring is completed.
i-Drive CAN bridge wiring work is completed.
Therefore, passenger seat control is enabled by the iDrive controller.
This system can enable useful features with low cost and easy installation.

6 Comments
  • Brian Ruskin
    Posted at 01:48h, 18 January Reply

    Could this be installed on a Hyundai i40 or should i go for the universal one WK-20DH?

    • INDIWORK
      Posted at 15:19h, 18 January Reply

      Hello. This module is for BMW only, but has been discontinued and is no longer sold. The WK-20DH module must be used to install walk-in system. Thank you.

  • Brian Ruskin
    Posted at 05:24h, 19 January Reply

    Hi, thx for the info!
    How much would cost shipping for the WK-20DH to Czech rep 62800?
    Thanks

    • INDIWORK
      Posted at 11:39h, 19 January Reply

      Hello. You can order from this site. Payment is made via PayPal, and order is shipped via DHL Express. Shipping cost is $26.28 USD(To Czech/~500g or less.) Please check the item detail inpormation before order. Thank you.

  • Brian Ruskin
    Posted at 15:59h, 20 January Reply

    Thx for the reply.
    One more question plz. I do own a Hyundai i40 euro spec model. I saw somewhere on the internet a m2c box installed on a korean i4o. My car is the facelifted 2015 model. The head unit is Mobis 4th gen(Infinity, no wifi) if i am not mistaken. Runs on android and is AA and CarPlay compatible. Do you know what kind of interfaces can be used with my head unit?

    • INDIWORK
      Posted at 17:48h, 20 January Reply

      For the CarPlay interface we sell, only for Mercedes, BMW, AUDI and Lexus. And in the case of Hyundai euro spec, the M2C Android box cannot be installed because the head unit specifications of the domestic and export models are different. Sorry.

Post A Comment