Kia All New Carnival Android Navigation M2C-100IW Installed

Kia All New Carnival Android Navigation M2C-100IW Installed

2017 Kia All New Carnival UVO In The INDIWORK Garage.

————-

* Car Android Navigation System With Original Touch Function

Devices Used :
– M2C-I00IW (Android Settop Box)
– HD-LINK Digital Multi Interface
– USB-AUX
– GPS FAKRA Cable

Start the installation.

Disassemble the AVN. The interface board is installed by connecting(IN/OUT) FPC film(Video) between original LCD and PCB.

The interface is installed on the original main PCB.

On the back of AVN of the All-New Carnival is the original DMB and GPS terminals. The FAKRA cables is connected to this terminals. Because the original terminal is used, the receiving sensitivity is very good.

This car has an ECM room mirror as standard. So the rear signal can be output from the room mirror, which is simple.
However, if it is so connected, if you change to the ‘P’ gear and then shift to the D gear, and when the monitor switches to the M2C screen immediately, you will not be able to properly use the original surround view function.
So, We install this in conjunction with the original ‘P’ button at the bottom of the gear knob box. In this way, the original surround view operates the same as before the settop installation according to the gear shift.

When installation is complete, reassemble the car parts.
[vc_video link=”https://youtu.be/CwEKQCbTEhc”]

2 Comments
  • Erwin Enriquez
    Posted at 14:35h, 17 May Reply

    Hi, do you sell the LCD screen that goes on the front passenger dash in the picture?

    • INDIWORK
      Posted at 10:52h, 18 May Reply

      Hello,
      Sorry,, we do not sell the LCD screen on the front passenger dash, and we do not have any information about it. Thank you.

Post A Comment