2010 Mercedes Benz E300 NTG4.0 Active Rear Parking Line & Sensor Creation

2010 Mercedes Benz E300 NTG4.0 Active Rear Parking Line & Sensor Creation

2010 Mercedes Benz E Class E300 In The INDIWORK Garage.

————-

Devices Used :
– IW-M-PAS (Rear Camera Interface)
Creation the PGS(Parking Guide-Line System) and PDC(Parking Distance Control).

This is the screen of the original rear camera. It is hard to feel a sense of distance because distortion is severe. It also does not provide a parking assist system (Active line and sensor).

The head unit version of Mercedes 2010 E300 model is NTG4.0. CAN BUS data is the same as NTG4.5 or AUDIO 20. So, we connect PAS CAN BUS HIGH and LOW in the CAN block on the side of the assistant foot plate.

The video line that controls the rear line is inside the trunk. So, power and rear video wiring are connected on the trunk inside. And the CAN BUS wiring connected from the front side must extend to the trunk and connect to the PAS rear interface.

This is the IW-M-PAS rear interface. size is small, and easy to install. When this is installed, moving parking guideline and obstacle detection sensor are created.

Installation is complete.

No Comments

Post A Comment