10 Aug [Mercedes Benz E300 (W213)] Easy Access & One Touch Memory Seat
▲ Mercedes Benz E300 (W213) – Easy Access & One Touch Memory Seat
Mercedes-Benz E-Class (E300 / W213) In The INDIWORK Garage.
Easy Access & One Touch Memory Seat
Use Device : EW200 Module
1. Easy Access
Easy Access is a system for the convenience of boarding and getting off.
When the vehicle is started, the seat automatically moves to the driving position,
When getting off the vehicle, the seat automatically moves backward so that the driver can get off easily.
2. One-Touch Memory Seat
The seat position provides three memory.
However, in order to move to the position memorized in position 1, it is necessary to hold the button until the move is completed.
So we programmed to move the sheet to that position by pressing the button once.
When I lift up the footrest of passenger seat to install the Easy Access CAN module on the Mercedes W213, the can block will be visible.
When I lift up the top of the CAN block, there are many wires.
I find the CAN control wiring among many wires and connect them with the CAN wiring of the CAN module.
You need to find and connect the CAN control wiring correctly.
And, the CAN wiring of the monitor and the P.A.S must be correctly identified and connected to the wiring of the CAN module.
Connect the Monitor CAN, P.A.S CAN, 12V power, and Ground in order.
The installation time is about 15 ~ 20 minutes and is very short.
After completing the Easy Access CAN Module installation, and restore the CAN block to its original state.
Use genuine buttons for operation. No separate switch is installed.
ON/OFF function is built in.
If you do not want to use this functions, press the HOME button on the handle for 5 seconds.
‘PIBIBIG ~!’ With the beep sound, both the Easy Access function and the Memory Seat function are disabled.
If you want to use this functions again, press the HOME button for 5 seconds.
‘PIBIC !’ With the beep sound, the Easy Access function and Memory Sheet function are activated.